ergoCentric upCentric UP-2LV Guide De L'utilisateur page 11

Step 6 :
Plug AC cable ( G ) and handset ( K ) into control box:
6.1 :
Plug AC cable ( G ) into back of control box.
6.2 :
Plug handset wire ( K ) into front of control box,
in the input marked "H".
6.3 :
Run handset wire through
the inlet hole on underside of frame
( plastic wire cover clips into inlet hole ).
There are 4 inlet holes, on both sides
of the frame, and at each end.
10 upCentric – UP-2LV Owner's Manual | Guide de l'utilisateur
®
Step 5 :
Add plugs ( C ) into holes
on each side of the frame.
6.1
6.3
6.2