Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Align visor to the previously cleaned surface. The visor attaches to
the surface of the door above the trim and to the rubber window
3
Apply pressure along all flanges to ensure proper adhesion of tape.
5
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International,
Inc. We take the utmost pride in our products and want you to enjoy years of satisfaction from your investment.
We have made every effort to ensure that your product is top quality in terms of fit, durability, finish and ease of
installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
seal.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2011 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the
remaining tape liner by pulling on free ends.
4
4 Piece Set
6
Repeat Steps 1-6 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
The rear visor attaches with the same
preparation methods as the front visor.
Publicité
