DRL BADGE HAND MOVIE REMOTE Mode D'emploi page 40

PIN code initialisation
By default, the PIN code is not enabled. =
1- The default PIN code is 0000.
Use or to select digit 0. 0 flashes, confirm it by
pressing .
1
2- For the remaining digits, select digit 0 by pressing
When 0000 is displayed, press
The PIN code is initialised and the device automatically
suggests the following setting: PIN code activation.
Activating / deactivating the PIN code
The screen displays
Press or to enable the PIN code
= PIN code enabled.
= PIN code enabled
Press to confirm and move to the next setting.
The PIN code has been enabled.
The settings listed under "Overview" cannot be changed.
PIN code customisation
When is displayed, press
The code 0000 is displayed and the 1st digit flashes.
With or , select the desired digit and then press
confirm it.
Proceed in the same way for the remaining three digits.
Cod. 1910000000381 - nv00
2
.
again to confirm.
for at least 5 seconds.
5 sec
to
1
Press to confirm. The new code has been stored. Press
again to close the PIN code configuration mode and return
to the beginning of the installer settings.
Press 3x to confirm and close the installer settings.
Reset to factory settings
If PIN code protection is disabled, user and installer settings can
be reset to their original values.
is displayed
flashes
Press or to select
Press for 5 seconds.
The device returns to the original configuration and automatically
activates the Auto mode.
- 35 -
English
2