DRL BADGE HAND MOVIE REMOTE Mode D'emploi page 37

English
Diagram of setting sequence:
Eco temperature reduction → Frost protection → Upper and
lower Comfort temperature limits → Ambient temperature
limitation → Surface temperature limitation → Maximum Boost
temperature → Reset to factory settings
14.16 Eco temperature reduction
Heating with ambient temperature setpoint:
The reduction is preset to -3.5°C based on the Comfort
reference temperature. It is possible to change it from -1°C to -
8°C, with 0.5°C intervals.
Important: regardless of the set reduction level, the Eco
reference temperature never exceeds 19°C.
Heating with surface temperature setpoint:
The reduction is preset to -30°C based on the Comfort reference
temperature. It is possible to change it from -5°C to - 60°C, with
5°C intervals.
Important: regardless of the set reduction level, the Eco
reference temperature never exceeds 45°C.
Press or to display the desired value
Ambient
temperature
control
To confirm and move to the next setting, press
confirm and close settings, press 2x
14.17 Frost Protection
Heating with ambient temperature setpoint:
The device is preset to 7°C. The Frost Protection value can be
changed from 5°C to 15°C, with 0.5°C intervals.
Heating with surface temperature setpoint:
is preset to 10°, the frost protection setpoint cannot be changed:
Press or to display the desired value
To confirm and move to the next setting, press
and close the settings, press 2x
Superficial
temperature
control
or . To
. To confirm
.
- 32 -
14.18 Minimum temperature limitation
Heating with ambient temperature setpoint:
The minimum threshold is preset to 7°C; it can be changed from
- 7°C to 15°C, with 1°C intervals.
Heating with surface temperature setpoint: The minimum
threshold is preset to 20°C; it can be changed from -20°C to
40°C, with 5°C intervals. To change the minimum threshold,
press or and confirm by pressing
want make any changes, press
suggests to set the maximum threshold. To confirm and close
the settings, press 2x .
Ambient
temperature
control
14.19 Ambient temperature limitation
The maximum threshold is preset to 30°C; it can be changed
from 19°C to 30°C, with 1°C intervals. Press
display the desired value. To confirm and move to the next
setting, press . To confirm and close the settings, press 2x
.
1
14.20 Surface temperature limitation
The maximum threshold is preset to 80°C; it can be changed
from 40°C to "no", with 5°C intervals. Press
display the desired value. To confirm and move to the next
setting, press . To confirm and close the settings, press 2x
.
. If you do not
: the device automatically
Superficial
temperature
control
or to
2
or to
Cod. 1910000000381 - nv00