DRL BADGE HAND MOVIE REMOTE Mode D'emploi page 39

English
14.23 Installer settings
Access
From Auto, Comfort, Eco or Frost Protection modes:
Press for 5 Information screens
seconds
1
Press for 10
= installer
seconds
settings
Diagram of setting sequence:
Open window detection → Optimisation function → Lock with
PIN code → Reset to factory settings
Open window detection
The automatic open window detection mode is active by default.
Press or .
= Automatic mode enabled.
= Automatic mode disabled.
Press to confirm and move to the next setting.
To confirm and close the settings, press 3x
Optimisation function
In OPTI ECO (energy efficiency) mode, the control calculates
the best compromise to ensure maximum energy savings
during programmed heating and cooling phases. A slight
reduction in temperature level at the beginning and end of the
comfort period permitted to maximise energy saving.
In OPTI COMFORT (comfort efficiency) mode, the control
calculates the best compromise to ensure maximum comfort
during programmed heating and cooling phases. Priority is
given to anticipating and maintaining the comfort temperature
during Comfort periods.
The OPTI COMFORT mode is activated by default. The word
OP /: / appears briefly on the display, then alternate with the set
ConF, ECO or OFF mode.
ConF= optimisation function enabled for OPTI COMFORT
mode, priority to comfort.
2 short Information
presses
screens
1
Short press
.
Press or .
= optimisation function enabled for OPTI COMFORT
mode, priority to comfort efficiency.
= optimisation function enabled for OPTI ECO mode,
priority to energy efficiency.
= optimization function disabled.
Press to confirm and move to the next setting.
To confirm and close the settings, press 3x
Lock with PIN code
Overview
You can set the 4-digit pin code yourself which, when activated,
makes the following functions unavailable:
• Selection of Comfort mode: only Auto, Eco and Frost
Protection modes are available.
• Setting the Comfort, Eco and Frost Protection
temperature.
• Changing the weekly program.
• Setting the open window detection
Three important steps are required when using "keyboard
through PIN code" protection for the first time:
1- PIN code initialization, enter the preset PIN code (0000) to
access the function.
2- PIN code activation to lock the settings to be protected.
3- PIN code customisation, i.e. replacement of the digits (0000)
with a customised four-digit code.
- 34 -
.
Cod. 1910000000381 - nv00