DRL BADGE HAND MOVIE REMOTE Mode D'emploi page 36

The end time flashes
and, with or
, this time can be
3.2
changed in 30-minute
intervals.
Press to save.
The second day (Tuesday) flashes. Repeat the
4
procedure described above for each day of the week.
After selecting a program for each day, confirm your
selection by pressing
displayed on the screen with the programs you set for
5
them. Press twice to exit programming mode and
return to "Automatic mode". If no button is pressed for
several minutes, the unit automatically returns to
"Automatic Mode".
14.12 Displaying the set weekly program
From Auto, Comfort, Eco or Frost Protection mode, press
for 5 seconds. Press twice (Comfort, Eco, P1, P2 or P3) on
the display in front of the user to scroll through the program for
each day of the week (Comfort, Eco, P1, P2 or P3). To exit
program display mode, press
14.13 Temporary change of weekly program
This function allows the temperature to be temporarily changed
until the next programmed temperature change or transition to
the next day.
Example:
The control is in Auto mode, the running program is Eco 15.5°C
in case of heating with ambient temperature setpoint and, e.g.,
30°C in case of heating with surface temperature setpoint
Ambient
temperature
control
By pressing or it is possible to temporarily change
the desired temperature to, e.g., 18°C in case of heating with
ambient temperature setpoint and, e.g., 45°C in case of heating
with surface temperature setpoint
Cod. 1910000000381 - nv00
1
2
. The days of the week are
twice.
Superficial
temperature
control
Ambient
temperature
control
This change is automatically cancelled at the next program
change or transition to the next day.
Ambient
temperature
control
14.14 Open window detection
The open window detection is sensitive to temperature
fluctuations. The control unit responds to open windows
according to various parameters: temperature setting, increase
and decrease of ambient temperature, outdoor temperature,
position of the control unit, etc. If the control unit is close to an
entrance door, the detection air can be disturbed by opening
the door. If this is a problem, we recommend disabling window
detection (see installer settings).
When, by opening a window, the control performs a temperature
reduction cycle, a frost protection counter is displayed to show
the cycle duration. The counter is automatically reset the next
time frost protection is activated. By pressing a button, the frost
protection mode is disabled.
Note: if a temperature increase is detected, the control
automatically returns to the previous mode.
14.15 User settings
Access
From Auto, Comfort, Eco or Frost Protection modes:
Long press for 5
seconds
Information screens
1
- 31 -
Superficial
temperature
control
Superficial
temperature
control
Information screens
1
= user
settings
English
2 short presses
Short press