Publicité
Les langues disponibles
Les langues disponibles
Lighting the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, slightly pull the switch trigger, and
then release it. The lamp goes out approximately 10
seconds after releasing the switch trigger.
1
Fig.4
► 1 . Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing and installing shear blades
CAUTION:
Never remove the blades with bare
hands. Wear gloves.
The sharp edge of the blade may cause injury.
Removing cutting head
Use the hex wrench (5/32") to loosen the bolts which
secure the cutting head. Pull the cutting head straight
out by turning it left and right alternately.
1
2
3
Fig.5
► 1. Cutting head 2. Bolt 3. Hex wrench (5/32") 4. Loosen
4
Removing shear blades
NOTICE:
Hold the blades and the sleeve not to fall
from the cutting head.
NOTICE:
Be careful not to lose the sleeve.
Remove the bolts which hold the blades. Then the
blades can be removed easily.
3
2
4
Fig.6
► 1 . Bolt 2. Side blade L 3. Center blade 4. Side blade
R 5. Sleeve
Installing shear blades
Insert the center blade, the side blade L, the side blade
R, and the sleeve into the cutting head.
Tighten the bolts. In this process, the bolt heads should
be protruding 2 - 3 mm from the cutting head surface.
If you tighten the bolts excessively, the cutting head
cannot be installed to the tool.
2
3
4
5
6
Fig.7
► 1 . Cutting head 2. Side blade R 3. Center blade
4. Sleeve 5. Sleeve 6. Side blade L 7. Bolt
7 ENGLISH
1
5
1
7
Publicité
