Starting And Stopping; Check Before Starting; Connect Battery To The Machine - Husqvarna 136LiHD50 Manuel D'utilisation

Check before starting

Li-ion Li-ion
• Inspect the working area. Remove any objects that
could be thrown out.
• Check the cutting attachment. Never use blades that
are dull, cracked or damaged.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Only use the machine for the purpose it was intended
for.
• Make sure that the handle and safety features are in
good working order. Never use a machine that lacks a
part or has been modified outside its specifications.
Gloves should be worn when necessary.
• All covers must be correctly fitted and undamaged
before you start the machine.

Connect battery to the machine

Make sure to use fully charged batteries. Use only a
Husqvarna original battery in your machine. See technical
data.
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly. The battery will lock itself into place
when you hear a click. Make sure the battery is fitted
correctly to the machine.

Starting and stopping

WARNING! Make sure no unauthorised
!
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety distance is 15
meters (50 ft.).
Starting
Turn on the machine. Press and hold the start button (>1
sec.) until the green LED is lit.
STARTING AND STOPPING
Press the front safety lockout up. It is placed on the front
handle.
Press the power trigger forward to release the power
trigger.
1
Then press the power trigger up to apply full power.
2
Stopping
Stop the machine by releasing the power trigger or the
power trigger lockout and deactivate the machine.
Remove the battery from the machine by pressing the two
release buttons and pulling out the battery.
IMPORTANT! Always remove the battery to prevent the
machine being started by accident.
–
English 15