EIBENSTOCK PLD 182.1 NT Notice Originale page 22

When securing the drill stand with a vacuum pad to the workpiece,

install the pad on a smooth, clean, nonporous surface. Do not
secure to laminated surfaces such as tiles and composite coating.
If the workpiece is not smooth, flat or well affixed, the pad may pull
away from the workpiece.
Ensure there is sufficient vacuum before and during drilling. If the

vacuum is insufficient, the pad may release from the workpiece.
Never perform drilling with the machine secured by the vacuum

pad only, except when drilling downwards. If the vacuum is lost, the
pad will release from the workpiece.
When drilling through walls or ceilings, ensure to protect persons

and the work area on the other side. The bit may extend through the
hole or the core may fall out on the other side.
Ensure that the drill is securely attached to the drill stand before

using it. Otherwise, the drill may slip in the drill stand, which can lead
to a loss of control.
Secure the drill stand on a stable and even surface. If there is a

chance that the drill stand will slip or wobble, the safe and steady
operation of the drill cannot be guaranteed.
Store idle drill stands out of the reach of children. Do not allow

persons unfamiliar with the tool or these instructions to operate
the tool. Tools can be dangerous in the hands of untrained users.
Before carrying out any work on the drill stand or drill, during

work breaks and when not using the drill stand, secure the drill
stand against unintentional movement by tightening the parking
brake.
The safety and operating instructions for the drill stand and the

accessories being used are to be strictly observed!
Always work in a carefully considered way and do not use the tool

if you are lacking consideration.
Store the machine in a safe manner when not being used. The

storage location must be dry and lockable. This prevents the
machine from storage damage, and from being operated by untrained
persons.
For further safety instructions, see the enclosure.
Electrical Connection
The PLD 182.1 NT is made in protection class I. For protection purposes
the machine can only be run with a GFCI. The machine is standard
equipped with a PRCD switch in the cord which allows to connect the unit
direct to a socket.
Attention!
The PRCD protective switch must not lay in water.

!
 PRCD protective switches must not be used to switch the tool on
and off.
Before starting your work, check the proper function by

the TEST button.
21
pressing