Store The Machine; Troubleshooting; Technical Data - GreenWorks DT40L00 Manuel D'utilisation

WARNING
Wear adequate clothing, gloves and goggles before
carrying out any maintenance.
WARNING
All the screws to mount the halves of the tine holder
(21) must be installed with washers (17) and lock
nuts(18) to avoid loosening during use.
1. Stop the machine.
2. Make sure that the cylinder fully stops.
3. Remove the battery pack.
4. Turn the machine to its side to expose the cylinder
(6).
5. Identify the worn or broken tine (20).
6. Untighten the screws (16), washers (17) and lock
nuts (18) to remove the tine holder (21) bearing the
worn or broken tine.
7. Take out the pin (19) and the worn or broken tine.
8. Replace with a new tine (20). Insert the pin (19)
through the new tine into the holder.
9. Re-install the tine holder back to the cylinder.
10. Tighten the screws, washers and nuts in original
order.
9.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
10

TROUBLESHOOTING

Abnormal noise. Foreign objects
on the dethatch-
er cylinder are
hitting the de-
thatcher.
Clattering in the Foreign objects
unit. Whistling blocking the de-
sound. thatching cylin-
der.
English
Whistling sound. Belt slipping.
Motor will not
start.
The dethatcher
is hard to push.
Dethatching re-
sults are not sat-
isfactory.
* If you cannot find the solution to these problems, go to
the service center.
11
Voltage
Switch off the
dethatcher, wait
No load speed
until the cylinder
Dethatching path
has stopped ro-
tating.
Dethatching depth
Remove foreign
Wheel size
objects.
Weight (without battery
Check the de-
pack)
thatcher immedi-
Battery model
ately.
9
Battery is not se-
cure.
Battery is not
charged.
Blocked by for-
eign objects.
The grass is too
tall.
Spring tine wear. Adjust the de-
Belt fault.
Lawn has grown
too tall.

TECHNICAL DATA

40 V
3600 RPM
14" (36 cm)
3/8" (1 cm)
7" (17.8 cm)
9.6 Kg
BAF724
EN
Contact an au-
thorized service
centre.
Ensure that the
battery is fully
secured in the
machine. Refer
to Install the Bat-
tery section in
this manual.
Charge the bat-
tery pack ac-
cording to the in-
structions inclu-
ded with your
model.
Switch off the
motor, wait until
the tine cylinder
comes to a com-
plete stop. Re-
move the foreign
objects. After ap-
proximately one
minute, switch
on the dethatch-
er.
Mow the lawn
before dethatch-
ing.
thatcher cylinder.
Contact an au-
thorized service
centre.
Mow the lawn
before using the-
dethatcher.