Interior Light; Storage; Door Lock; Cleaning Your Wine Cellar - Cavavin C-050WSZ Manuel D'instruction

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Interior light

To turn the interior light ON or OFF, press the
button. The light will be turned off automatically
if it remains ON for 10 minutes. To turn it on again, press the
button again and the light will
turn back on.

Storage

Many bottles may differ in size and dimensions. As such the actual number of bottles you may be
able to store may vary. You can place 50 standard bottles in this wine cellar.

Door Lock

Your unit is provided with a lock and key. The keys are located inside the plastic bag that contains
the Instruction Manual. Insert the key into the lock and turn it counter clockwise to unlock the door.
To lock the door do the reverse operation making sure metal pin is engaged completely. Remove
the key and place it in a secure place for safekeeping.

Cleaning your wine cellar

Turn off the power, unplug the appliance, and remove all items including shelves. Wash the inside
surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons
of baking soda to 1 cup of water.
Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth
when cleaning area of the controls, or any electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth. Do not use steel wool or steel brush on the stainless steel. These will
contaminate the stainless steel with steel particles and rusting may occur.

Shelves

This appliance is equipped with a pull-out roller assembly (except for the bottom shelf) and you can
move the wooden shelves out and in smoothly.
To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment. For easy access to the bottles, you must pull the
shelves approximately 1/3 out of the rail compartment.
To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat
screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift the
left plastic notch as shown in Figure B. Then proceed to pull out the shelf slowly.
Figure A
Figure B
27

Publicité

Chapitres

Table des Matières
loading

Table des Matières