ECOVACS ROBOTICS DEEBOT OZMO 937 Mode D'emploi page 15

Install Side Brushes
2
Attach Side Brushes to the bottom of
DEEBOT by pressing a brush into each
slot with the matching color until it clicks.
Power ON
3
Open the Top Cover. Move the Power Switch to
the ON position. "I"=power ON; "O"=power OFF.
The Control Panel illuminates, and DEEBOT
plays a musical tune. DEEBOT is powered ON
when the Control Panel stays illuminated.
* When DEEBOT is not cleaning, it is
suggested to keep it powered ON and
charging instead of powered OFF.
4
Charge DEEBOT
Place DEEBOT on the Docking Station
making sure the Charging Contacts on
DEEBOT and the Docking Station Pins make
a connection.
Charge DEEBOT for at least 4 hours before
the first use.
*
Please make sure the Power Switch is turned ON before charging. ("O" indicates OFF and "I"
indicates ON).
*
AUTO Mode Button blinks slowly when DEEBOT is charging. AUTO Mode Button stops
glowing when DEEBOT is fully charged.
*
When DEEBOT completes the cleaning cycle or when battery power gets low, DEEBOT
automatically returns to the Docking Station to recharge itself. DEEBOT can also be sent
back to the Docking Station at any time by using ECOVACS App or by pressing the AUTO
Button on the robot for 3 seconds.
*
Empty any remaining water from the Reservoir and remove the Cleaning Cloth Plate before
charging DEEBOT.
3. Operating and Programming
13
EN