Télécharger Imprimer la page

Nilfisk FOOD Hybrid Foamatic MA2CM Mode D'emploi page 18

Publicité

7. System preparation
7.1. Start up of new system
In order to ensure a problem-free start up of a new
system the pipe system and pump must be flushed
and bled.
Bleeding the pipe system
1. Turn on the water supply to rinse and bleed the
entire system. If satellites are installed open the
tap furthest away until no air or dirt comes out.
Then rinse and bleed the next tap and continue
until the tap closest to you has been rinsed and
bled.
Bleeding the pump
1. Loosen the relief plug (A) (drawing 0627131)
1-2 revolutions until water and air begin to flow out.
Never loosen the relief plug while the pump
is running as this may damage the packing.
Tighten the relief plug again.
2. Start the pump so that all remaining air pockets
are forced up to the top of the pump.
3. Stop the pump
4. Loosen the relief plug 1-2 revolutions again and
bleed the system until only water flows out.
5. Tighten the relief plug once more.
A
DETAIL A
The mainstation is now ready for operation.
7.1.1.
Start
1. Make sure that the water and air supply to the
unit is open. For air see layout drawing. In case
of central chemical supply this must be activated
too.
2. Select requested function. Use the unit according
to the "User guide".
18
7.1.2.
Stop
1. Press"
2. Close the water supply (see drawing 110005285-
page 14).
3. Close the air supply (see drawing 110005288-
page 14).
4. Deactivate chemical supply by pulling up the suc-
tion hose or removing the User Pack.
Due to the following it is very important
to close water, air and chemical supply
when the unit is not in use.
7.1.3.
Adjustment of air
Remove the cover from the unit.
Adjust the air pressure on the reduction valve until an
appropriate foam quality is reached.
When setting the regulator, carefully
pull up the knob and turn it clockwise
for pressure increase and counter clock
wise for pressure decrease.
0627131
" to stop program if running.
• If the air supply is open when the
unit is not in use - air might seep
into the water pipe - which means
that the system has to be bled
again.

Publicité

loading