Publicité
Les langues disponibles
Les langues disponibles
Finish
Using the Recording Timer
The clock has a 12-hour display.
Radio broadcasts can be recorded at a programmed time.
Example:
Recording radio broadcasting from 1:00 P.M. to
2:30 P.M.
Setting the start and finish times
KI Press POWER.
2 | Press TIMER ADJUST to set "ON (REC)" flash-
ing.
ON [A]> OFF [A]>ON [B]}> OFF [B]
[I originel display
OFF
—ON
(The display changes each time the button is pressed.}
Press +/pp| or —/¢q
while "ON (REC)" is
flashing to set the start time.
@) Press TIMER ADJUST.
Finish time flashes.
®© Press +/ pp or —/H@d to set the finish time.
@) Press TIMER ADJUST.
Display returns to original mode.
When "E" is displayed:
Check whether start and finish are set for the same time.
Programming recording
H Get the music source ready.
@) Select radio station.
@) Insert cassette into deck 2.
@ Press REV MODE on the remote control to select the mode.
®Reduce the volume when listening during recording is not
desired.
elf there is excessive interference when recording an AM sta-
tion, press ST/MONO/BP to switch to reduced static.
Setting the timer function
6 Press REC TIMER to display "REC".
When "E" is displayed:
Check whether the clock has been set (page 9).
Press POWER to turn the unit off.
Programming can be checked when the unit is off (page 27).
The unit turns on approximately 30 seconds before the set start
time and recording begins.
To clear the timer function:
Press REC TIMER when the unit is on to clear the
indicator.
Publicité
