Electrolux EUT 11004W Notice D'utilisation page 56

56 electrolux
Problem
Cooling is too weak.
Cooling is too strong
No cooling at all.
Noisy operation
Green indicator
flashing
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm
indicator will start to flash. The product will continue to operate with the use of a
reserve system until the problem is eliminated by the local service personnel.
GB
Possible cause
Thermostat is set too low.
No sufficient pre-cooling done
before freezing started.
Too large food inserted:
Too much food inserted for
freezing at the same time.
Food inserted while still hot.
Door not fully closed.
Thermostat is set too high.
Plug is not properly inserted
into socket.
No current in socket.
Thermostat set to "0" position.
Product support is not correct.
Temperature sensor problem.
Solution
Set to higher position.
Provide for sufficient pre-
cooling time.
Cut food into pieces.
Insert less food.
Insert food of max. room
temperature.
Check if door is fully closed.
Set to lower position.
Check plug-socket
connection.
Check presence of current.
Check thermostat setting.
Check stability of product
support (all four feet should
stand on floor).
Call the service personnel.