Ga.Ma GT527 Mode D'emploi page 9

1. Make sure that the appliance is switched off.
2. Plug the adapter into the USB port of your PC, Notebook or Tablet and then connect it to the device. A
standard USB adapter (5V 1000 mA) may be used. The charging LED will light up and remain red for
the whole charging process.
3. The first charge takes 16 hours. Subsequent charges take about 8 hours. When fully charged, the battery
will last about 45 minutes.
4. Once it is fully charged, disconnect the adapter from the USB port of your PC, Notebook or Tablet or from
the power outlet.
5. If the beard trimmer charge runs out during use, since it a slow-charging cordless product, it must be
charged for around 2 hours before using it again.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the
batteries, this procedure should be carried out at least twice every 12 months, discharging the battery
completely and recharging it for the maximum time. If the appliance is not used often, remember in any case
to carry out a charging cycle every so often during the year to keep it working efficiently. On the contrary,
when the charging is finished, do not keep the appliance connected to the mains to prevent the battery from
overcharging and damaging the appliance.
WARNING: Do not attempt to replace the internal battery of the beard trimmer. This can lead to the risk
of fire or electric shock. Tampering invalidates the warranty on the product.
CAUTION:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO
LUBRICATE THE BLADE"
USE INSTRUCTIONS:
• Insert the attachment. This operation should always be done with the beard trimmer turned off.
• Turn on the beard trimmer by pressing the (O/I) button.
• Turn off the beard trimmer by pressing the (O/I) button.
12
INSERTION OF THE COMB:
The supplied comb has two lateral seats for an easier snapping on the base. To insert it on the beard trimmer,
lay the blade on the comb and make it slide on the comb until you hear a slight click: the comb will thus be
properly inserted. To remove the comb just extract it making the blade slide outwards.
REMOVAL OF THE HEAD:
To remove the head, grasp the beard trimmer by the front side, place your thumb over the head and push
backwards until the head is completely removed.
INSERTION OF THE HEAD:
There is a black interlocking seat inside the upper part of the beard trimmer; on the head there is a black lever.
To insert the head, place the black lever on the interlocking seat; push toward the front of the appliance until
you hear a slight click: the insertion procedure is now complete.
CUTTING LENGTH ADJUSTMENT:
The GT527 Sport beard trimmer offers the possibility of making finishing touches of 0.4 mm (if used without
any guide comb attached) and trimming beard with the following lengths: 3, 4, 5 , 6 and 7 mm.
CLEANING AND MAINTENANCE:
A clean and properly lubricated beard trimmer considerably improves its capacity and cutting precision.
CLEANING THE HEAD:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet. Remove the accessory if it is inserted. Using the special brush supplied, remove any hair
residues between the blades and the back of the blade head.
NEVER DISASSEMBLE THE HEAD OF THE BLADE OR YOU WILL INVALIDATE THE WARRANTY ON
THE ENTIRE PRODUCT.
13