Panasonic SC-SB1 Mode D'emploi page 11

Bluetooth connection
®
By using the Bluetooth connection, you can listen
®
to the sound from the Bluetooth
from this system wirelessly.
≥ Refer to the operating instructions of the Bluetooth
for further instruction on how to connect a Bluetooth
device.
Preparation
≥ Turn on the Bluetooth
®
place the device near this system.
Bluetooth pairing
®
1
Press [ ] to select "
≥ If the " " indicator flashes quickly, go to step 3.
2
Press and hold [ ] until the "
flashes quickly.
≥ If the " " indicator flashes slowly, repeat step 2.
3
Select "SC-SB1" from the Bluetooth
device's Bluetooth
®
≥ If prompted for the passkey on the Bluetooth
enter "0000".
≥ Once the Bluetooth device is connected, the "
®
indicator stops flashing and lights up.
≥ You can register up to 8 devices with this system. If a 9th
device is paired, the device that has not been used for the
longest time will be replaced.
Connecting a paired Bluetooth
device
1
Press [ ] to select "
≥ If the " " indicator lights, a Bluetooth
already connected with this system. Disconnect it.
( below)
2
Select "SC-SB1" from the Bluetooth
device's Bluetooth
®
∫ Disconnecting a Bluetooth
Press and hold [ ] until the "
≥ This system can only be connected to one device at a time.
All manuals and user guides at all-guides.com
audio device
®
® device
®
feature of the device and
".
" indicator
®
menu.
device,
®
"
®
".
device is
®
®
menu.
device
®
" indicator flashes.
Advanced operations
Auto Power Down
This system is automatically turned off if there is no audio
input and when you do not use it for approx. 19 min and
30 sec.
1
While pressing
and holding
[i SUBWOOFER]
on the remote control, press and hold
[VOL s] on this system for more than
4 sec.
≥ The current mode will be indicated by the
corresponding LED indicator.
2
While the current mode is indicated (about
20 sec), press [i SUBWOOFER] again.
≥ The setting changes each time [i SUBWOOFER] is
pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is "On".
Bluetooth Standby
®
This function allows you to connect a paired Bluetooth
device when this system is in standby mode.
1
While pressing
and holding
[SUBWOOFER j]
on the remote control, press and hold
[VOL s] on this system for more than
4 sec.
≥ The current mode will be indicated by the
corresponding LED indicator.
2
While the current mode is indicated (about
20 sec), press [SUBWOOFER j] again.
≥ The setting changes each time [SUB WOOFER j] is
pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is "On".
"On" "Off"
®
"On" "Off"
11
TQBS0132 (11)