Waterpik WP-100 Serie Mode D'emploi page 8

All manuals and user guides at all-guidesbox.com
8
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash
and antibacterial solutions. After using any special solution, rinse
unit to prevent clogging by partially filling reservoir with warm
water and running unit with tip pointed into sink until unit is
empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the
product when necessary by using a soft cloth and mild non-
abrasive cleanser. The water reservoir is removable for easy
cleaning and is top rack dishwasher safe.
NOTE: Remove reservoir valve before placing reservoir in
dishwasher.
Remove Replace
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the
mineral content of your water. If left unattended, it can hinder
performance.
Cleaning internal parts: add 2 tablespoons of white vinegar to a
full reservoir of warm water. Point the handle and tip into sink.
Turn unit ON and run until reservoir is empty. Rinse by repeating
with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure
optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses and
handles can be purchased from your local distributor, which can
be found at www.waterpik.com/intl.
If leakage occurs from the reservoir, ensure the valve is right side
up or contact your local distributor for a replacement valve.