Inventum VKI5510ZWA Mode D'emploi page 22

ELECTRICAL CONNECTION
Attention: this hob includes a power cord with a plug. The connection is a 1 fase-connection.
• Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
• The earthing of the appliance is compulsory by law.
• Attention: the connection point must always be accessible.
8
problems & solutions
If there is an error, an error code will be shown at the displays.
Error code Cause
E1 Supply voltage is too high.
E2 Supply voltage is too low.
E3/E4 The cooking zone is overheated.
E5/E6 The hob is overheated.
F3/F4
F5/F6 Induction sensor is defect.
F7/F8
F9/FA
Coil temperature sensor is defect.
FC/FD
22
• English
Solution
Have the installation checked by a qualified electricien.
Have the installation checked by a qualified electricien.
Wait for the temperature of the cooking zone to drop and switch it on again.
Switch the appliance off and let the cooking zones cool down.
Contact the service department of Inventum.
Contact the service department of Inventum.