Telcoma Automations T101F Instructions Pour L'installation page 49

GB
If this does not suffice for the gate to fall within the limits shown by the regulatory charts, we recommend you fit a
soft rubber profile on the top of the gate to deaden the impact. If, after adjusting sensitivity and fitting the rubber,
the gate still does not meet the standard's requirements, it is compulsory to fit alternative devices, such a sensing
edge, on the gate's mobile edge.
SOFT START
The soft-start function determines a gradual start of movement without jolts on the gate. This function may in any
case be bypassed by inserting the jumper Jp1 (part 9 of Fig. 1).
Attention: by activating jumper Jp1 the motor force will always be at the maximum.
SLOWING DOWN
If any recoils of the gate are noted when passing from normal to a lower speed on an installation where the
slowdown function is used, the mode of passage may be changed as follows:
A - cut off the power supply
B - press the pushbuttons PP and STOP on the control unit simultaneously (parts 6 and 7 of fig. 1)
C - reconnect to the power supply, keeping the buttons pressed.
D - the LED L1 (part 17 of fig. 1) gives a short signal that the passage is successful.
To return to the initial configuration, simply repeat the above procedure.
FINAL TEST AND INSPECTION
Always carry out a final test and inspection after having completed all the programming.
- Check correct operation of the protective devices (anti-crushing system, stop pushbutton, photocells, safety
edges, etc.).
- Check correct operation of the warning devices (flashing lights, open gate warning light, etc.).
- Check correct operation of the control devices (P/P button, remote controls, etc.).
49