Telcoma Automations T101F Instructions Pour L'installation page 47

GB
1) Shut off power supply to control unit.
2) Position the gate or door at mid-travel.
3) Press PROG/STOP button.
4,5,6) Switch on power to control unit by keeping the PROG./STOP button (part 6 of fig.1) pressed for at least 3
seconds. Programming LED L1 comes on.The same function can be obtained by holding the PROG./STOP
button down, shorting the reset pins (part 15 of fig. for a moment then releasing the PROG./STOP button
when LED L1 comes on.
7) Issue a pedestrian command signal, the motor closes.
8,9) Once the motor has reached the closing stroke limit, it stops and the opening stroke starts automatically.
10) Issue another pedestrian command signal at the desired opening.
11) The gate stops and then closes automatically.
12) Once the motor has reached the closing stroke limit, it stops and LED 1 switches off.
PEDESTRIAN opening programming: Typology 2
MOTOR WITHOUT ELECTRIC LIMIT SWITCHES AND ENCODER
1
7
1) Shut off power supply to control unit
2) Position the gate or door at mid-travel.
3) Press PROG/STOP button
4,5,6) Switch on power to control unit by keeping the PROG./STOP button (part 6 of fig. 1) pressed for at least 3
seconds. Programming LED L1 comes on. The same function can be obtained by holding the PROG./STOP
button down, shorting the reset pins (part 15 of fig. 1) for a moment then releasing the PROG./STOP button
when LED L1 comes on.
7) Issue a pedestrian command signal, the motor closes.
8,9) Once the motor has reached the closing stroke limit, it stops and the opening stroke starts automatically.
10) Issue another pedestrian command signal at the desired opening. The gate stops and then closes
automatically.
11) Once the closing stroke is complete, press the P/P button again. The motor stops.
12) Programming LED L1 switches off.
2 3
9
8
PED PED
4 5
10 11
PED PED
6
12
47