Télécharger Imprimer la page

DeWalt DW233K Mode D'emploi page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
E N G L I S H
• Rotate the side handle to the desired position
and tighten the handle.
Setting the drilling depth (fig. B)
• Insert the required drill bit into the chuck.
• Slacken the side handle (5).
• Fit the depth adjustment rod (6) through the hole
in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse switch (fig. C)
• To select forward or reverse rotation, use the
forward/reverse-switch (3) as shown
(see arrows on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Two gear selector (fig. D)
Your tool is fitted with a two gear selector (4) to vary
the speed/torque ratio.
• Release the ON/OFF-switch and select the
required position. This can be done with the tool
switched OFF or running under no load
condition. Always align the selector with the
arrow on the gear housing:
1 low speed/high torque
(drilling large holes, driving large screws)
2 high speed/low torque
(drilling smaller holes, drilling in wood)
For speed rates, refer to the technical data.
Do not change gears at full speed or
during use.
Chuck removal (fig. E)
• Open the chuck jaws as far as possible.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (9) by turning clockwise.
• Tighten an Allen key (10) into the chuck and
strike it with a hammer as shown.
en - 5
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply only a gentle pressure to the tool.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
Prior to operation:
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
Switching ON and OFF (fig. A)
• To run the tool, press the variable speed switch (1).
The pressure exerted on the variable speed switch
determines the tool speed.
• If necessary, press the lock-on slide (2) upwards
for continuous operation and release the switch.
The lock-on slide works only in full speed,
forward rotation.
• To stop the tool, release the switch.
• To stop the tool in continuous operation,
press the switch briefly and release it.
Always switch OFF the tool when work is finished
and before unplugging.
Screwdriving
• Select forward or reverse rotation.
• Use the low speed/high torque position
(1st gear).
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
17

Publicité

loading