DeWalt DW233K Mode D'emploi page 20

E N G L I S H
17 Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Inspect the
E
extension cords periodically and replace them if
damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function.
Check for misalignment and seizure of moving
parts,breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Heavy duty rotary drill
1 Side handle
1 Depth gauge
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
en - 3
Description (fig. A)
Your D WALT drill has been designed for
E
professional drilling and screwdriving applications.
1 Variable speed switch
2 Lock-on button
3 Forward/reverse switch
4 Two gear selector
5 Side handle
6 Depth adjustment rod
7 Keyless chuck
8 Sleeve
Torque limiting clutch
All rotary drills are equipped with a torque limiting
clutch that reduces the maximum torque reaction
transmitted to the operator in case of jamming of a
drill bit. This feature also prevents the gearing and
electric motor from stalling. The torque limiting
clutch has been factory-set for heavy duty
performance and cannot be adjusted.
For safe operation, always use the side
handle, particularly when working in the
low speed/high torque position (1st gear).
Synchronized gear shifting mechanism
Your drill is equipped with a synchronized gear
shifting mechanism which allows to use the two gear
selector when the tool is switched OFF or running
under no load condition.
Electronic speed control
The electronic speed control offers the following
advantages:
- optimal tool control for accurate drilling
- easier screwdriving
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
15