Publicité
Les langues disponibles
Les langues disponibles
- Keep the bottle cap away from children to avoid suffocation.
- Do not allow children to play with small parts or walk/run while using bottles.
- Inspect all parts before use and pull the feeding nipple in all directions. Throw away any part at
the first signs of damage or weakness.
- Always discard any breast milk that is left over at the end of a feed.
Caution: To avoid damage to the bottle
- Do not place in a heated oven, plastic can melt.
- Plastic material properties may be affected by disinfection and high temperatures. This can
affect the fit of the bottle cap.
- Do not leave a feeding nipple in direct sunlight or heat, or leave in disinfectant for longer than
recommended because this may damage the product.
Before using the bottle
- Inspect the bottle and feeding nipple before each use and pull the feeding nipple in all
directions to prevent a choking hazard. Throw away at the first signs of damage or weakness.
- Clean and disinfect the bottle before first use and after every use (see 'Cleaning and
disinfecting').
Assembling the bottle
1. The nipple is easier
to assemble if you
move it back-and-forth
while pulling it
upwards instead of
pulling it up in a
straight line.
2. Make sure you pull
the nipple through
until its lower part is
aligned with the screw
ring.
3. Make sure you place
the cap vertically onto
the bottle so that the
nipple sits upright.
English
4. Screw the screw ring
with nipple and cap on
the bottle.
21
Publicité
