Greencut GLM700X Manuel D'utilisation page 92

92
TO REMOVE THE SPARK PLUG
1. Pull the cap (B) of the electric cable (A)
2. Clean the area around the spark plug so that no dirt or other materials
can enter the engine when the plug is removed.
3. Use the spark plug tool (C) to remove the spark plug (turn
counterclockwise).
To reassemble the spark plug
1. Place the spark plug in its hole and screw it in (to the right) until it is
tight enough.
2. Use the spark plug tool to tighten the spark plug by approximately a
quarter turn (no over threading)
3. Place the electric wire over the spark plug and push it down so that it
connects firmly to the terminal.
REPLACING THE BLADES
ATTENTION: For more safety, before performing this operation check that the machine is completely
off and the spark plug removed. Remember to drain the oil from the oil tank before removing the
blade.
If you want to replace the cutting blades, remove the bolt. Proceed with installation according to the picture provided.
The upward swing of the blade must be projected into the engine compartment.. When replacing the blade, also
replace the clamp bolt and washers.
B
A
C