Greencut GLM700X Manuel D'utilisation page 84

84
SIDE DISCHARGE INSTALLATION
ATTENTION: Remove all grass before using your machine with the side discharge.
Lift the side discharge cover with one hand and hook the side discharge line with the other hand. Release the side
exhaust flap to secure the line in position.
PRODUCT USE
BEFORE USING THE PRODUCT
AIR FILTER
The air filter is used to prevent dirt and other particles from possibly entering the engine causing internal damage to it.
The air filter requires regular maintenance. Always check the air filter before starting the engine.
STROKE ENGINE OIL
The product is NOT supplied with engine oil, although there may be traces of oil from factory. It is important to add
suitable engine oil to the engine before using it. Failure to add engine oil will void the guarantee.
Four-stroke engines require engine oil in the crankcase for the lubrication of internal components. Severe or irreparable
damage may occur if the engine is allowed to run without engine oil.
The engine oil level requires regular maintenance. Check the engine oil level and ensure that the oil level is at or just
under the maximum level indicator. Always check the engine oil level before starting the engine.
FUEL
ATTENTION: The engine must be cold before filling the tank.
Adequately fill the fuel tank with the correct fuel type. Use non-ethanol unleaded petrol (higher RON values will
provide best engine performance). Do not use old or contaminated fuel.
To fill or top up fuel:
1. Place the machine in an upright position on a flat and level surface.
2. Clean the machine around the fuel filler so that no dirt or other material enters the engine when the cap
is removed.
Side discharge cover
Side discharge chute