Gorenje BHI681EB Prescriptions De Montage Et Mode D'emploi page 12

Operation
The hood is fitted with a control panel with aspiration speed
selection control and a light switch to control cooking area
lights.
a. ON/OFF lighting
b. OFF motors
c. - d. - e. Minimum suction power (c.), medium
maximum (e.).
On some models ONLY:
A Non Return Backdraft Damper is included in the supply, as optional
accessory to be installed under certain installation conditions (i.e. if
there is no protection against accidental backdraft of air from the
outside). The damper must be installed inside the dedicated housing,
inside of the Air Outlet Fitting, before installing the flue.
Maintenance
Clean using ONLY a cloth dampened with neutral liquid detergent.
DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Grease filter
Fig. 1-7
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher, which
must be set to a low temperature and a short cycle. When washed in
a dishwasher, the grease filter may discolor slightly, but this does not
affect its filtering capacity.
Charcoal filter (filter version only)
Fig. 5
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the regularity of
cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every four
months.
The charcoal filter may NOT be washed or regenerated.
(d.),
Replacing lamps
Fig.7
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled
down.
Remove the suction gril to access the lamp area.
Replace the damaged lamp.
Use E14 3W max LED lamps only. For more details, check enclosed
leaflet "ILCOS D" (alfanumeric position "1d").
If the lights do not work, make sure that the lamps are fitted properly
into their housings before you call for technical assistance.
11