Publicité
7
5
6
2
A
B
1
A
2
3
B
C
4
B
Threading
Lower looper (red)
- Place the spool on the
spool holder pin.
- Bring thread up from back to front
through guide (1).
- Pull the thread under the
protector (2) and pass under the
guider up to go around the
pre-tension (3)
- Thread guide (4,5,6,7).
- Turn the balance wheel
toward you until the lower
looper extending out
5-10mm from the needle
plate edge.
- Pull the thread
with tweezers to pass the
lower looper hole (A).
- Draw the thread with your left
hand tightly.
- Use your finger to push the
automatic threader (B) up to the
5~10mm
topmost, and then thread goes
through the lower looper ( )
automatically.
27
C
Publicité
