Husqvarna 540XP Mark III Manuel D'utilisation page 36

Saw chain speed at 133% of maximum engine power
speed, ft/s / m/s.
Recommended cutting equipment
A specific chainsaw model has to be evaluated with
the cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 540XP Mark III met the
safety requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note:
Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Approved cutting equipment - 540XP Mark III
Guide bar
Length, in/cm Pitch, in
12/30 3/8
14/35
16/40
12/30 0.325 mini
14/35
16/40
Pixel
Pixel is a guide bar and saw chain combination that is
more light weight and designated to offer more energy
efficient use by cutting narrow cuts. Both guide bar and
saw chain need to be Pixel to get these benefits. Pixel
cutting equipment is marked with this symbol.
36
Accessories
Gauge, in/mm Max. nose ra-
dius
0.050/1.3 9T
0.043/1.1 8T
Husqvarna 540XP Mark III
87.3/26.6, 88.3/26.9
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Note:
The usable cutting length is usually 1 in less
than the nominal guide bar length.
Saw chain
Type
Husqvarna
S93G
Husqvarna
SP21G
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain.
A Husqvarna file gauge makes sure that you get the
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
Length, drive Low kickback
links (no.)
45 Yes
52
56
51 Yes
59
64
1679 - 005 - 02.11.2022