Changing The Audio Gain Setting - Sony WRT-847A Mode D'emploi

Settings
The next time you turn on the transmitter (by setting the
POWER switch to ON), the transmitter will enter
Transmitting mode with the selected channel number (or
frequency).
Notes
• The transmitter cannot transmit in Setting mode.
• Make sure that the channel selected on the transmitter is
the same as that selected on the tuner being used in the
same system.
• Depending on the noise or interference conditions, all
selectable channels may not be usable. If necessary, you
can determine which channels are usable by cycling the
channel selection through a number of channels on the
tuner with the unit set to OFF. Those channels for which
the RF indicator on the tuner does not light are usable.
• The transmitter may not operate correctly if it is turned on
immediately after being turned off in Setting mode. Wait
for a few seconds before turning the power on again.
• The channel numbers and frequencies of your transmitter
are shown on the "Sony Wireless Microphone System
Frequency List" supplied with the manual.
10
(GB)

Changing the Audio Gain Setting

You can change the audio input gain within a range of
–12 dB to +9 (in 3-dB steps) in either Setting mode or
Transmitting mode.
When the audio input is excessively strong and distortion
occurs, reduce the input gain by setting it to "–12 dB" to
"–3 dB". When the audio input is excessively low, raise the
input gain by setting it to "+3 dB" or "+9 dB". The factory
preset setting is "0 dB".
Changing the audio gain in Setting mode
1
Set the transmitter to Setting mode.
2
If the audio gain indication ("GAIN-" or "ATT-") is not
displayed, press the SET button until it appears.
3
Press the + or – button to change the audio gain setting.
AF RF BATT
+ button
– button
Hold down the button to change the level quickly.
AF RF BATT