Tineco FLOOR ONE S7 COMBO Serie Mode D'emploi page 20

Maintenance
Note:
• For optimal performance and to prevent odors, always clean and dry DWT, filters, brush roller,
brush roller cover completely after each use.
• Please make sure each part is installed correctly or the appliance may not work properly.
• Do not soak the appliance or wash it under water.
• Some water may remain in the appliance due to factory inspection.
• After maintenance, place the appliance on the charging dock vertically. Do not expose the
appliance to direct sunlight, and store it indoors in a dry place.
Main Body
To reduce the risk of injury, switch off before
performing maintenance.
Dirty Water Tank
①
• When dirty water reaches the Max line, the appliance will stop working and show a reminder on
the display and play a voice prompt.
• Pull up the tank lid to empty the DWT. Use the cleaning tool to remove remaining debris. Rinse
the inside of the DWT and place back into the appliance.
② ③
Clean the dirt sensor with a damp cloth or the
cleaning tool.
④
18
⑤