Control Board; Functioning - OEM FX Série Mode D'emploi Et D'entretien

Chapter 5
5.1 - CONTROL BOARD AND SIGNALLING
LAMPS (Fig 1)
On the machine you can find following control elements:
1. Timer
The timer has three positions:
" "
allows the machine manually to function, to start the
cycle press " " or "
concerned model, to stop the cycle press "
"0"
the machine functioning is disabled.
"Minute counter (1a)"
It is possible to set the machine functioning minutes
(from 0 to 30 minutes) by turning the timer knob (1)
clockwise, then press "
the concerned model, to start the cycle; the latter
ends when the timer knob (1) reaches "0".
2. Green starting push-button "
enabled by turning the timer knob (1) on "
the minute counter.
If you press it, the machine starts.
3. Red stop push-button "
If you press it, the machine stops.
4. Green starting push-button "
(If any)
Enabled by positioning the timer knob (1) on "
on the minute counter.
If you press it, the machine starts.
GB - 16
", depending on the
".
" or " ", depending on
" 1st speed.
" or onto
"
" 2. speed.
"or
FIG. 1
1
1
FX / RVE

Functioning

2
3
2
3
4