Heath Zenith 4395 Mode D'emploi page 4

All manuals and user guides at all-guides.com
OPTIONAL WIRING
This fixture is provided with a sensor rated for 360 Watts. Since the fixture is only rated 100 Watts, 260 Watts of additional
lighting may be controlled by this sensor.
When determining what a fixture is rated for, do not simply look at the rating on the bulb in the fixture. Look at the
marking which specifies the maximum bulb wattage for which the fixture is suitable.
Once you have selected the fixtures to be connected and determined their maximum ratings, add these ratings up.
For instance, if you have 3 fixtures rated 100 Watts, 150 Watts, and 75 Watts respectively, you have a total load of 325
Watts.
Wiring Diagram 1 – When wiring to control a standard light fixture: Strip the motion sensor's red wire and con-
nect to the standard light's black wire. Connect all white wires together. Total fixture ratings must not exceed 360 Watts
(3.0 A).
Wiring Diagram 2 – When wiring to control another motion sensing light fixture (Master / Slave): Strip the
red wire in both light fixtures. Connect the red wire of the controlling (master) fixture to the red and black wires of the
controlled (slave) fixture. Connect all white wires together. Total fixture ratings must not exceed 360 Watts (3.0 A).
Wiring Diagram 3 – When wiring so either motion light turns on the both motion lights (Master / Master):
Strip the red wire in both light fixtures. Connect the red wire of one fixture to the red wire of the second fixture. Note:
In most installations, an additional wire (same gauge as existing house wire) will have to be installed in the house to
connect the two fixtures as master / master. Connect all white wires together and all black wires together. Total fixture
ratings must not exceed 360 Watts (3.0 A).
Master Slave
(Standard)
Red
Red
Black Black
Green or Green or
Bare Bare
White White
Wiring Diagram 1 Wiring Diagram 2
Master Master
Red
Black
Green or
Bare
White
Wiring Diagram 3
4
204069-01