Ryobi TS1143L Manuel D'utilisation page 14

INSTALLING BATTERIES FOR LASER
See Figure 12.
 Remove screw from battery compartment cover using
the Phillips end of the supplied blade wrench. Remove
cover and set aside.
 Install two AAA batteries according to polarity indicators
inside the battery compartment.
 Replace the battery compartment cover. Reinstall screw
and tighten securely.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls, adjustments, or performance of pro-
cedures other than those specified here can result in
hazardous radiation exposure.
ALIGNING THE LASER GUIDE LINE
See Figure 13.
Unplug the saw. Using a square, draw a straight line on the
workpiece. When the laser guide switch is turned on it will
generate a red line on the work surface. This line will let you
see your mark and the laser guide line at the same time,
and will assist you in lining up the mark for more accurate
cutting of the workpiece.
NOTE: The broken line may begin slightly skewed off of the
mark in the uppermost position. As the saw blade assembly
is lowered, at the approximate point the lower blade guard
starts to move, the laser line will be aligned with the mark and
remain aligned throughout the cut. This is normal. NEVER
attempt to move the workpiece while making a cut. Always
keep hands outside the "No Hands Zone".
Once both lines are in alignment, do not move the workpiece.
Plug the saw into the power source. Make several practice
cuts on different styles and thickness of material. Repeat
the steps above as necessary.
Removing Your Mark:
Position the laser line near the left edge of your mark on the
work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on
the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
ASSEMBLY
LASER GUIDE
SWITCH
14
BATTERIES
Lock
trigger prior to adjusting
laser. AVOID EXPOSURE:
Laser radiation emitted
from this aperture.
Fixer gâchette avant
laser est réglagé.
EVITER L'EXPOSITION :
Rayonnement laser
émise de cet orifice.
Asegure gatillo antes de
ajuste de laser. EVITE LA
EXPOSIOCIÔN: Radiactiôn
laser se emite por esta
abertura.
LASER
LINE
COMPARTMENT
COVER
SCREW
Fig. 12
Fig. 13