Dell PowerEdge 4220 Guide D'installation page 21

Insert the hinge pin into the hinge body.
i
Insert the retention clip through the hinge so that the retention clip
j
is below the spring.
4 Reverse the bottom hinge body.
Remove the Allen bolts that secure the hinge body to the rack,
a
and place the bolts in a safe location.
Rotate the hinge body 180 degrees so that the hinge posts are now
b
on the other side of the hinge body (see Figure 1-8).
Locate the bottom bolt holes in the right side of the rack, and use the
c
Allen bolts to fasten the hinge body to the right side of the rack.
5 Rotate the front door 180 degrees so that its hinge-pin housings are on the
right side (see Figure 1-9).
Figure 1-9. Rotate the Front Door
Installation Guide
19