Reversing The Front Door (Optional) - Dell PowerEdge 4220 Guide D'installation

Reversing the Front Door (Optional)

NOTE:
Use a 4-mm Allen wrench to remove the front-door hinge bodies from the rack
and reinstall them on the side opposite their original positions. You might need a
stepladder in order to access the Allen bolt that secures the top hinge body to the rack.
To reverse the direction that the front door opens, complete the following steps:
1 Remove the front door (see "Removing the Front Door" on page 8).
2 Remove the side panels (see "Removing and Replacing the Side Panels" on
page 12).
3 Reverse the top hinge body.
Pull the hinge pin slightly upward so that you can access the retention
a
clip (see Figure 1-7).
Using the needle-nose pliers, remove the retention clip, and slide the
b
hinge pin out of the hinge body.
16
Installation Guide