Removing And Replacing The Side Panels - Dell PowerEdge 4220 Guide D'installation

Masquer les pouces Voir aussi pour PowerEdge 4220:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
Lay the door in a safe location with the door's outer surface
d
facing upward.
Laying the door flat with the outer surface facing upward helps
prevent damage to its cosmetic coating.
Repeat step a through step d for the left back door.
e
Replacing the Back Doors
To replace the back doors, perform the steps for removal in reverse.

Removing and Replacing the Side Panels

CAUTION:
before running systems in the rack to ensure proper cooling within the rack.
NOTE:
You must remove the lower side panels in order to install the side
stabilizer feet.
NOTE:
Although removing the side panels is not mandatory for installing
systems in a rack, having the sides open makes it easier to install slide assemblies
and support rails and to reverse the direction that the front door opens.
Removing the Upper Side Panels
1 Push both latches up and swing the bottom end of the panel away
from the rack (see Figure 1-4).
2 Grasp firmly on each side of the panel.
3 Lift the panel upward until the panel lip clears the top of the rack.
4 Lay the panel in a safe location with the panel's outer surface facing
upward to help prevent damage to its cosmetic coating.
5 Repeat step 1 through step 4 for the other upper side panel.
Replacing the Upper Side Panels
1 Lift the upper side panel up onto the rack, hooking the panel lip over the
top of the rack (see Figure 1-4).
2 Swing the bottom of the panel downward onto the rack.
3 Press the panel into the rack until both latches lock into place.
12
Installation Guide
For stand-alone racks, reinstalling the side panels is necessary

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Poweredge 4820

Table des Matières