Samsung FE710DRS/XAC Manuel D'utilisation page 8

Installing a 4-wire power cord
WARNING
WARNING
located in the lower center of the terminal block. The power leads must be connected to the lower left
and the lower right terminals of the terminal block. The 4th grounding lead must be connected to the
frame of the range with the ground plate and the ground screw.
1. Remove the 3 lower terminal screws from the terminal block. Remove the ground screw and
ground plate and retain them.
2. Cut and discard the ground strap. Do not discard any screws.
3. Insert the one ground screw into the power cord ground wire terminal ring, through the ground
plate, and into the frame of the range.
4. Insert the 3 terminal screws (removed earlier) through each power cord terminal ring and into the
lower terminals of the terminal block. Be certain that the center wire (white/neutral) is connected
to the center lower position of the terminal block. Tighten screws securely into the terminal block.
5. Go to step 5 on page 10 and proceed with the installation.
Ground strap
Ground plate
8_ Connecting the power
Installation_XAC_DG68-00109F-01_EN+CFR.indb 8
The neutral wire of the supply circuit must be connected to the neutral terminal
White
Black
White
Black
Red
Ground
screw
Neutral
terminal
Red
Ground
wire
(Green)
2012-02-21 6:48:50