Olympia A-260 Mode D'emploi page 9

Operation
Connect the power cable to an easily accessible, standard electrical socket.
Caution: Check that the voltage specifications of the unit correspond
to that of your power supply network (230 V, 50 Hz).
Switch on the On/Off switch on the right-hand, top side of the unit
(Position "I").
The drive motor for the transport rollers starts up, the red indicator lamp
(POWER) lights up and the warm-up phase begins. The correct operating
temperature is reached after about 6 minutes and the green indicator lamp
(READY) lights up.
Insert the document to be laminated in the foil pocket so that there is a mar-
gin of approx. 5 mm to the edge of the foil on all sides.
Insert the foil containing the document in the laminator's insertion slot. Insert
the ready closed side of the foil in first.
Note: To prevent the laminating foil from creasing, never insert the
open end of the foil pocket in the insertion slot of the laminator first.
When inserting the foil, observe the instructions on the insertion slot.
The laminating process occurs automatically.
Caution: The foil is very hot and soft when ejected following lamina-
tion. Therefore, handle the laminated product with extreme care.
Note: To flatten the laminated product, place a book or similar
heavy, flat object, on it.
Servicing, Cleaning and Troubleshooting
Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the proc-
ess several times.
All manuals and user guides at all-guides.com
9