Black & Decker EPC126 Mode D'emploi page 8

ENGLISH
Chargers
• Use your BLACK+DECKER charger only
to charge the battery in the tool with
which it was supplied. Other batteries
could burst, causing personal injury and
damage.
• Never attempt to charge
non-rechargeable batteries.
• Have defective cords replaced
immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor
use only.
Read the instruction manual before
use.
The charger automatically shuts
off if the ambient temperature
becomes too high. The thermal
cut out operates only once and
then requires complete
replacement.
Electrical safety
Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the
rating plate. Never attempt to
replace the charger unit with a
regular mains plug.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the
following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
8
All manuals and user guides at all-guides.com
(Original instructions)
4. Chuck
5. Speed selector
6. Bit holder
7. Battery
Fig. A
8. Charger plug
9. Charger
10. Charger receptacle
Assembly
Warning! Before assembly, remove the
battery from the tool.
Fitting and removing the battery (fig. B & C)
• To fit the battery (7), line it up with the
receptacle on the tool. Slide the battery
into the receptacle and push until the
battery snaps into place.
• To remove the battery, push the release
button (11) while at the same time pulling
the battery out of the receptacle.
Fitting the battery cap (fig. C)
Warning! Fit the cap (12) to the battery (7)
for transportation and storage.
Fitting and removing a drill bit or
screwdriver bit (fig. D)
This tool is fitted with a keyless chuck to
allow for an easy exchange of bits.
• Lock the tool by setting the
forward/reverse slider (2) to the centre
position.
• Open the chuck by turning the front part
(13) with one hand while holding the rear
part (14) with the other.
• Insert the bit shaft (15) into the chuck and
firmly tighten the chuck.
This tool is supplied with a double-ended
screwdriver bit in the bit holder (6).
• To remove the screwdriver bit from the
bit holder, lift the bit from the recess.