Cleaning And Maintenance; Safety Advice - Bartscher 150.340 Mode D'emploi

The automatic temperature control
1. As the temperature control is a highly sensitive part you should prevent the device
from falling down, avoid shocks or concussions.
2. Always use the provided automatic temperature control only, which is delivered with
this multi pan or an absolutely identically constructed model from the manufacturer.
Do not use another control.
3. Make sure the automatic temperature control is plugged in properly. When plugging
out do not pull the cord but only the plug of the automatic temperature control.
Do not plug in or pull out the plug too strong.
4. Always keep clean the temperature sensor and the poles of the socket.
5. In case the automatic temperature control is damaged or overheated you should
immediately turn it off and stop the use and contact your local contractor.
Precautions to take while operating the heating surface
As the hotplate has a non-sticking coating takes
note of the following advice:
•
Do not use a sharp metal spatula.
•
Do not cut the meal directly on the hotplate (when cutting
beefsteak make sure you first put it on a plate).
•
Do not set the temperature control on top of the hotplate
as it must not touch the surface.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!
- 27 -