Initial Operation, Relay, Total Running Time (Date Of Initial Operation, Relay Switching Rate, Total Running Time) - Selve i-Timer Plus Notice D'utilisation

Programming
FUNCTION
(only when the operating device is disconnected, only for
qualified electricians)
INITIAL OPERATION, RELAY, TOTAL RUNNING TIME
(Date of initial operation, relay switching rate, total running time)
EXPERT
Con-
MODE
tinuation
OFF/ON
+/-
1. You have confirmed the ALARM SIGNAL ON/OFF. EXPERT
MODE OFF/ON will appear.
2. You can select the required setting using the +/- button.
3. Confirm your selection by pressing OK.
4. INITIAL OPERATION will appear.
5. Confirm by pressing OK. RELAY will appear. (RELAY denotes
the relay switching rate.)
6. Confirm by pressing OK. TOTAL RUNNING TIME will appear.
(TOTAL RUNNING TIME denotes the overall running time of
the timer.)
7. Confirm your selection by pressing OK.
8. Press the MENU button to switch to operating mode.
OK
INITIAL
OPERATION
77
OK OK
RELAY
GB
OK
TOTAL
RUNNING TIME
FUNCTION