Selve i-Timer Plus Notice D'utilisation page 49

Installation/Connection
Connection as a group controller
PE
L1
N
Individual UP
Individual DOWN
GROUND
Group UP
Group DOWN
3. Put the protective caps back on the power supply unit.
4. Fix the power supply unit in the box.
5. Put the operating device in the frame and plug it into the power
supply unit.
Light sensors
Note: A light sensor can be connected to the device. See operating
instructions for the i-Light Sensor.
PE
L1
N
Individual UP
Individual DOWN
GROUND
Group UP
Group DOWN
N L1 DOWN C
mains
i-Timer Plus
light sensor
low-level signal connection
N L1 DOWN C UP
mains
i-Timer Plus
low-level signal connection
UP
49
GB
M 1
~