Publicité
Les langues disponibles
Les langues disponibles
C
Secondary
and final
filters
Removing
and installing
filter
bag
Grasp filter bag collar (A) and pull collar
from tube (B).
Note: Do not clean out old filter bag and
reuse. Discard used filter bag.
Hold new filter bag as shown. Align open-
ing in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.
Replacing
bag
door
Reposition bag door by placing tab on
bottom of doer into opening (C).
Press top of door to snap securely shut.
Cleaning
secondary
filter
Disconnect
cleaner
from electrical
outlet.
The secondary filter (A), located
behind the grill in the bottom of bag
compartment,
protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and lift
out filter.
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this filter,
ask for HOOVER part No. 38765019.
Replacing
final
filter
The final filter assists in the filtration
process to return clean air to the room.
The final filter can be washed in the
same manner as the secondary
filter
and reused.
To remove final filter, first open the door
on the side of the cleaner (Fig. 3-6).
Grasp filter (B) and pull it straight out.
Reposition new filter by reversing this
procedure.
Should you want to replace this filter,
ask for HOOVER part No. 40110006.
Do not operate cleaner without both
the secondary and final filter in place.
m
How
to reattach
filter
door
The filter door is designed with a "break-
away" feature which allows it to snap
free if it is pushed open too far.
To reattach, align hinges (C) of cover
with slots on sides of filter area.
Press door back into place.
Check
brush
roll chan-
nels
Because your WindTunnel
TM
cleaner
picks up so well, we strongly recom-
mend you check for debris accumulation
in the channels next to the brush roll
when you check the filters.
Removing
this debris will help maintain you clean-
er's excellent pick up and suction.
Remove debris as follows:
Disconnect cleaner from electrical
outlet.
Check for debris accumulation
by
removing bottom plate (Fig. 3-9) and
looking in the channels next to the brush
roll (Fig. 3-18).
Remove any accumulation.
Reposition bottom plate (Fig. 3-13).
Headlight
replacement
What
to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, Hoover part No.
27313101.
Removing
lens
Disconnect cleaner from electrical
outlet.
Using a Phillips screwdriver, remove the
two screws as shown and lift off lens.
Continued
_
9
Publicité
