Publicité
Les langues disponibles
Les langues disponibles
Looking at the back of the cleaner,
make sure switch (A) is in the OFF
position•
Slide handle into back of cleaner.
Push screws into holes on back of
handle•
Using a Phillips screw driver, tighten
screws securely.
Remove switch lock (B) above ON-
OFF switch (C) on front of handle by
pulling it straight out. Dispose of
lock.
If switch lock has come off during
assembly, make sure switch is in
OFF position (down) before plug-
ging cord into electrical outlet.
Remove label (D) from self-propel
button•
NOTE:
Hose
must
be connected
as shown
for
all
operations.
Align end of hose with projection (E)
over slots (F) in dirt duct on back of
handle.
F
Slide hose into (F) and twist hose to
lock it into place.
G
Position hose over rack and into
hose tube (G).
r,..lu.-
/
r,..lu
H
i
Place smaller diameter end of wand,
into bottom of rack. Snap wand into
clip at the top. Repeat with other
wand.
Snap dusting brush (H), crevice tool
(I) and furniture nozzle (J) into stor-
age area on back of cleaner.
Open tool cover.
The powered hand tool is shipped in
a plastic bag for protection.
Remove tool from storage area and
discard bag. Reposition tool and
close tool cover.
Publicité
