Operation Pole Hedge Trimmer - IKRA GM 6050 Pro Mode D'emploi

Remove transport protection
Before starting with the installation as described in the
operating instructions, please carry out the following
steps:
1. Pull the inner telescopic tube approx. 5 cm out of the
outer sleeve.
2. Then remove the rubber stopper. This is only required
as transport protection for the cable.
ca. 5 cm
2
Assembly
1. Rotate the knob (14) of the telescopic tube anticlock-
wise ( ) to loosen the tube.
14
2. Rotate the knob (14) of the head tube clockwise ( )
1
14

Operation pole hedge trimmer

Pivoting the Power Head
The Pole Trimmer is equipped with a power head that
pivots. The power head has a spring-loaded button that
allows it to be locked into several different positions
within its 120-degree rotation. Before connecting the Pole
Trimmer to the electrical supply, make sure the power
head is locked into position. Do this by trying to rotate the
power head in either direction. The power head should
be locked in position and should not rotate. To pivot the
power head, follow the instructions below.
1. Push the round button (3) located on the side of the
2. Grasp the power head motor housing and rotate the
GB-10
to tighten the head part.
WARNING: Read and understand this owner's
manual before operating Pole Trimmer. Make cer-
tain you read and understand all Safety Warnings
of this manual. Improper use of this Pole Trimmer
can result in severe injury or death from fire, electric
shock, or body contact with moving parts.
Disconnect the pole trimmer from the power supply.
pivot bracket. The button is spring-loaded, so you will
feel some resistance when pulling it out.
power head to either of the 5 positions (-30° / 0° /
30° / 60° / 90°).