Niko 10-282 Mode D'emploi page 16

10-282 / 10-382
Enter the access code (4 digits) and press #. If the access code is correct, the following message is displayed (for 1s):
Code: ✻✻✻✻
Door is open
If the access code is not correct, the following message is displayed (for 1s):
Code: ✻✻✻✻
Incorrect code!
If an incorrect code is entered three consecutive times, the functon will be disabled for 128s.
POSSIBLE SETTINGS
adjusting the volume on the external unit
You can adjust the volume of the microphone (volume on the internal unit) and the loudspeaker (volume on the external unit) with the potentiometers on the
printed board of the external unit (fig.3). Turn left to decrease the volume, turn right to increase the volume.
potentiometer for loudspeaker (volume on external unit)
potentiometer for microphone (volume on internal unit)
4. PRODUCT MaINTENaNCE
With the following maintenance tips Niko wants to prevent the surface of your product being damaged due to improper handling.
• Clean the product with a little soap and a damp cloth.
• Never use:
- abrasive sponges or abrasive detergents;
- maintenance products containing solvents or acids, or cleaning products containing acetic acid
Damage by improper handling is not covered by the guarantee.
5. TECHNICaL DaTa
- Dimensions 10-282: front plate: ................. 320 x 150 x 3mm
flush mounting frame: 296 x 132 x 50mm
- Dimensions 10-382: front plate: ................. 425 x 150 x 3mm
flush mounting frame: 401 x 132 x 50mm
- Operating temperature: .............................. -20 to 50°C
- Display: ..................................................... 2 line LCD display (max. 16 characters/line)
- Max. number of house numbers: ................ 200
- Max. current consumption: P-wire: ............. 120mA (audio); 250mA (video)
bus (a, b): ......... 0.4 mA
6. LEGaL WaRNINGS
- The installation has to be carried out by a registered installer and in compliance with the statutory regulations.
- This user manual has to be handed over to the user. It has to be included in the electrical installation file and has to be passed on to any new owners.
Additional copies are available on the Niko website or via the support service.
- During installation, the following has to be taken into account (not limited to list below):
- The statutory laws, standards and regulations;
- The state of the art technique at the moment of installation;
- This user manual, which must be read within the scope of each specific installation, only states general regulations;
- The rules of proper workmanship
- In case of questions, you can consult Niko's support service or contact a registered control organisation.
Support Belgium:
+32 3 778 90 80
website : http://www.niko.be
e-mail: support@niko.be
In case of a defect, you can return your product to a registered Niko wholesaler, together with a clear description of your complaint (Conditions of use, stated
defect...).
7. GUaRaNTEE PROVISIONS
- Period of guarantee: 2 years from date of delivery. The delivery date is the invoice date of purchase of the product by the consumer. If there is no invoice,
the date of production applies.
- The consumer is obliged to inform Niko in writing about the defect, within two months after stating the defect.
- In case of a failure to conform, the consumer has the right to a repair or replacement (decided by Niko) free of charge.
- Niko cannot be held liable for a defect or damage as a result of an incorrect installation, improper or careless use or wrong usage or transformation of the goods.
- The compulsory regulations of the national legislation concerning the sales of consumer goods and the protection of the consumers in the countries where
Niko sells, directly or via sister or daughter companies, chain stores, distributors, agents or permanent sales representatives, take priority over the rules and
regulations mentioned above.
16
All manuals and user guides at all-guides.com
Support UK:
+44 1525877707
http://www.nikouk.com
e-mail: sales@nikouk.com
EN