Niko 10-282 Mode D'emploi page 15

10-282 / 10-382
3. OPERaTION aND USE
For a detailed description of the programming, see manual of the PC interface!
Via the PC interface (10-xxx) you can program 200 names (max. 24 characters) and house numbers consisting of max. 4 digits (0 up to and including 9999).
To each house number you can link 1 or 2 serial numbers (e.g. internal units).
If you wish to call more internal units in parallel, you have to program them according to the Master-Slave principle. Manually, you can only program a few
internal units as Master-Slave. With the service set (10-870), you can program all internal units according to this principle.
If the installation has been carried out correctly and the system is connected to the mains, the following message will be displayed for approx. 5s. The serial
number is displayed at the bottom left and the software version number at the bottom right.
Niko 10-282
SN: 1108 V1.08
Als daarna de volgende boodschap op het display verschijnt, staat de buitenpost in stand-by en is klaar voor gebruik.
Enter number
or press ✻
3.1. Call via house number
Dial the apartment or house number on the code keypad (e.g. 123). The number is displayed for 15s. An alternating message is displayed on the 2nd text
line. Follow the instructions.
apartment: 123
call with # delete with ✻
Press button ✻ to delete a digit.
Press button # to set up a call.
The following message is displayed for 15s:
call apt. 123
Janssens An
If the call is answered, the following message is displayed (for 15s):
talk to
Janssens An
3.2. Call via name list
- Press ✻
- The following message is displayed (for 15 sec):
initial letter
choose with ✻
- Press ✻ to read the next message. An alternating message is displayed on the 2nd text line. Follow the instructions.
A
choose with ✻ confirm with #
Use button ✻ to select the first letter of the name you are searching. Only the first letters that are in the name list will be displayed. Press button # or wait
15s to open the name list that starts with the selected letter. Press button 0 to return to the standby screen. At the desired first letter (e.g. J), press button
#. The first name starting with J is displayed:
Janssens An
choose with ✻ call with #
Press button ✻ to search the name (ordered alphabetically).
Press button 0 to return to the standby screen.
Then press button # to set up a call.
The following message is displayed for 15s:
call apt. 123
Janssens An
If the call is answered, the following message is displayed (for 15s):
talk to
Janssens An
3.3. Open door or gate via access code
Press button #. The following message is displayed (for 15s):
code:
confirm with # delete with ✻
EN
All manuals and user guides at all-guides.com
apartment: 123
A
back with 0
Janssens An Janssens An
back with 0
code:
A
15