Télécharger Imprimer la page

Husqvarna K970 IIl Chain Manuel D'utilisation page 27

Publicité

Les langues disponibles

Les langues disponibles

Loosen the bolts holding the spring cassette.
Remove the recoil spring by turning the starter over
and loosen the hooks, with the help of a screwdriver.
The hooks hold the return spring assembly on the
starter.
Lubricate the recoil spring with light oil. Fit the pulley
and tension the recoil spring.
Fitting the starter
To fit the starter, first pull out the starter cord and place
the starter in position against the crankcase. Then
slowly release the starter cord so that the pulley
engages with the pawls.
Tighten the screws.
Fuel system
General
Check that the fuel cap and its seal are not damaged.
Check the fuel hose. Replace when damaged.
Fuel filter
The fuel filter sits inside the fuel tank.
The fuel tank must be protected from contamination
when filling. This reduces the risk of operating
disturbances caused by blockage of the fuel filter
located inside the tank.
The filter cannot be cleaned but must be replaced with
a new filter when it is clogged. The filter should be
changed at least once per year.
26 – English
MAINTENANCE
Air filter
The air filter only needs to be checked if the engine drops
in power.
Loosen the screws. Remove the air filter cover.
Check the air filter and replace if necessary.
Replacing the air filter
!
NOTICE!
The air filter must not be cleaned or blown clean with
compressed air. This will damage the filter.
Remove the screw.
Replace the air filter.
Drive gear, clutch
Check the clutch centre, drive gear and clutch spring
for wear.
CAUTION! Unhealthy dust can be spread
during filter change. Wear approved
respiratory protection. Dispose of filters
correctly.

Publicité

loading