Ir Remote Control (Optional) - Cameo RGBWA+UV WITH W-DMX Manuel D'utilisation

DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
SYSTEM INFORMATION (System Info)
Settings
Starting from main display 1, press MENU to enter the main menu. Using UP and DOWN, select the menu item System Info and confirm
System Info
with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for accessing the system information (see table, selection with UP and DOWN, confirm with ENTER,
change status with UP and DOWN, confirm with ENTER).
System Info
Firmware = Displays device fi rmware
Temperature = Displays temperature of
LED unit
Operation Hours = Displays operating time
MANUAL LOCKING FUNCTION
In addition to the ability to automatically protect the lamp from accidental and unauthorised operation (see "Settings" – "Auto Lock"), the
controls can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. "LOCKED"
is now displayed and it is no longer possible to change the spotlight's settings via the controls. After approx. eight minutes, the current
operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. The
display will show the previously displayed information.

IR REMOTE CONTROL (optional)

Activate the infrared remote control in the system settings (Settings) under "IR
Remote" (IR Remote On). Aim the infrared remote control directly at the infrared
sensor built into the front of the spotlight. The maximum range is approximately
8 metres. Deactivate control via the infrared remote control (IR Remote Off) when
you wish to control the spotlight via DMX cable and W-DMX.
BL (ON/OFF / Blackout)
Press the BL button to switch off all LEDs (blackout), regardless of the operating
mode enabled via remote control. Press the BL button again to reactivate the
previously selected mode.
SP (Speed)
Speed setting for the color change programme in Auto Program (PG) operating
mode. Select a color change program, press the SP button and then use the + and
- buttons to set the desired speed from 000 to 100.
☼ ☼ (Brightness)
Pressing the button for setting brightness immediately activates the Static opera-
ting mode. The overall brightness can now be set using the + and - buttons
(set value is show in display).
14
Firmware
V1.xx
LED xxx°C / xxx°F
C/F Unit Celsius (= display in degrees Celsius)
Unit Fahrenheit (= display in degrees Fahrenheit)
Total Displays total operating time in hours and minutes
xxxx:xxh